Specifications

area default cost
SecureStack C3 Configuration Guide 16-25
Mode
Routerconfiguration:C3(su)‐>router(Config‐router)#
Defaults
Ifno‐summaryisnotspecified,thestubareawillbeabletoreceiveLSAs.
Example
ThefollowingexampleshowshowtodefineOSPFarea10asastubarea:
C3(su)->router(Config)#router ospf 1
C3(su)->router(Config-router)#area 10 stub
area default cost
UsethiscommandtosetthecostvalueforthedefaultroutethatissentintoastubareaandNSSA
byanAreaBorderRouter(ABR).Thenoformofthiscommandremovesthecostvaluefromthe
summaryroutethatissentintothestubarea.
Syntax
area area-id default-cost cost
no area area-id default-cost
Parameters
Defaults
None.
Mode
Routerconfiguration:C3(su)‐>router(Config‐router)#
Usage
TheuseofthiscommandisrestrictedtoABRsattached tostubandNSSAareas.
Example
Thisexampleshowshowtosetthecostvalueforstubarea10to99:
C3(su)->router(Config)#router ospf 1
C3(su)->router(Config-router)#area 10 default-cost 99
area‐id Specifiesthestubarea.ValidvaluesaredecimalvaluesorIPaddresses.
cost Specifiesacostvalueforthesummaryroutethatissentintoastubareaby
default.Validvaluesare24‐bitnumbers,from0to16777215.