Specifications

redistribute
SecureStack C3 Configuration Guide 16-11
redistribute
Usethiscommandtoallowroutinginformationdiscoveredthroughnon‐RIPprotocolstobe
distributedinRIPupdatemessages.Thenoformofthiscommandclearsredistribution
parameters.
Syntax
redistribute {connected | ospf process-id | static} [metric metric value]
[subnets]
no redistribute {connected | ospf process-id | static}
Parameters
Mode
Routerconfiguration:C3(su)‐>router(Config‐router)#
Defaults
Ifmetricvalueisnotspecified,1willbeapplied.
Ifsubnetsisnotspecified,onlynon‐subnettedrouteswillberedistributed.
Example
ThisexampleshowshowtoredistributeroutinginformationdiscoveredthroughOSPFprocessID
1non‐subnettedroutesintoRIPupdatemessages:
C3(su)->router(Config)#router rip
C3(su)->router(Config-router)#redistribute ospf 1
connected Specifiesthatnon‐RIProutinginformationdiscoveredviadirectly
connectedinterfaceswillberedistributed.
ospf SpecifiesthatOSPFroutinginformationwillberedistributedinRIP.
process‐id SpecifiestheprocessID,aninternallyusedidentificationnumberforeach
instanceoftheOSPFroutingprocessrunonarouter.Validvaluesare
1to
65535.
static Specifiesthatnon‐RIProutinginformationdiscoveredviastaticrouteswill
beredistributed.Staticroutesarethosecreatedusingtheiproute
commanddetailedin“iproute”onpage15‐20.
metricmetricvalue (Optional)Specifiesametricfortheconnected,OSPForstatic
redistributionroute.This
valueshouldbeconsistentwiththedesignation
protocol.
subnets (Optional)Specifiesthatconnected,OSPForstaticroutesthatare
subnettedwillberedistributed.