Specifications

Configuring RIP
16-2 IPv4 Routing Protocol Configuration
Configuring RIP
Purpose
Toenableandconfigurethe RoutingInformationProtocol(RIP).
RIP Configuration Task List and Commands
Table 16‐1liststhetasksand comm andsassociatedwithRIPconfiguration.Commandsare
describedintheassociatedsectionasshown.
Table 16-1 RIP Configuration Task List and Commands
To do this... Use these commands...
Enable RIP configuration mode. “router rip” on page 16-3
Enable RIP on an interface. “ip rip enable” on page 16-3
Configure an administrative distance. “distance” on page 16-4
Allow reception of a RIP version. “ip rip send version” on page 16-5
Allow transmission of a RIP version. “ip rip receive version” on page 16-5
Configure RIP simple authentication. “ip rip authentication-key” on page 16-6
Configure RIP encrypted authentication. “ip rip message-digest-key” on page 16-7
Disable automatic route summarization
(necessary for enabling CIDR)
“no auto-summary” on page 16-8
Activate split horizon or poison-reverse. “split-horizon poison” on page 16-9
Suppress sending routing updates. “passive-interface” on page 16-9
Control reception of routing updates “receive-interface” on page 16-10
Control advertising non-RIP routes. “redistribute” on page 16-11