Specifications

SecureStack C3 Configuration Guide 16-1
16
IPv4 Routing Protocol Configuration
ThischapterdescribestheIPv4RoutingProtocolConfigurationsetofcommandsandhowtouse
them.
Activating Advanced Routing Features
Inordertoenableadvancedroutingprotocols,suchasOSPF,DVMRP,VRRP,PIM‐SM,and
extendedACLs,onaSecureStackC3device,youmustpurchaseandactivatea licensekey.Ifyou
havepurchasedanadvancedroutinglicense,andhaveenabledroutingonthedeviceasdescribed
inpreviouschapters,you
canactivateyourlicenseasdescribedin“ActivatingLicensedFeatures”
onpage3‐29.Ifyouwishtopurchaseanadvancedroutinglicense,contactEnterasysNetworks
Sales.
Router: The commands covered in this chapter can be executed only when the device is in router
mode. For details on how to enable router configuration modes, refer to “Enabling Router
Configuration Modes” on page 14-3.
For information about... Refer to page...
Activating Advanced Routing Features 16-1
Configuring RIP 16-2
Configuring OSPF 16-12
Configuring DVMRP 16-36
Configuring IRDP 16-40
Configuring VRRP 16-45
Configuring PIM-SM 16-54
Note: The command prompts used in examples throughout this guide show a system where the
VLAN 1 interface has been configured for routing. The prompt changes depending on your current
configuration mode, your specific device, and the interface types and numbers configured for
routing on your system.