Specifications

Reviewing IP Traffic and Configuring Routes
SecureStack C3 Configuration Guide 15-19
Reviewing IP Traffic and Configuring Routes
Purpose
ToreviewIPtrafficandconfigureroutes,tosendrouterICMP(ping)messages,andtoexecute
traceroute.
Commands
ThecommandsusedtoreviewIPtrafficandconfigureroutesarelistedbelow:
show ip route
UsethiscommandtodisplayinformationaboutIProutes.
Syntax
show ip route [destination-prefix destination-prefix-mask longer-prefixes |
connected | ospf | rip | static | summary]
Parameters
Defaults
Ifnoparametersarespecified,allIProuteinformationwillbedisplayed.
Mode
Anyroutermode.
For information about... Refer to page...
show ip route 15-19
ip route 15-20
ping 15-21
traceroute 15-22
destination‐prefix
destination‐prefix‐
masklonger‐
prefixes
(Optional)Convertsthespecifiedaddressandmaskintoaprefixand
displaysanyroutesthatmatchtheprefix.
connected (Optional)Displaysconnectedroutes.
ospf (Optional)DisplaysroutesconfiguredfortheOSPFroutingprotocol.For
detailsonconfiguringOSPF,referto“ConfiguringOSPF”onpage 16‐12.
rip (Optional)DisplaysroutesconfiguredfortheRIProutingprotocol.For
detailsonconfiguringRIP,referto“ConfiguringRIP”onpage 16‐2.
static (Optional)Displaysstaticroutes.
summary (Optional)DisplaysasummaryoftheIProutingtable.