Specifications

Configuring Broadcast Settings
SecureStack C3 Configuration Guide 15-17
Configuring Broadcast Settings
Purpose
ToconfigureIPbroadcastsettings.
Commands
ThecommandsusedtoconfigureIPbroadcastsettingsarelistedbelow:
ip directed-broadcast
UsethiscommandtoenableordisableIPdirectedbroadcastsonaninterface.Thenoformofthis
commanddisablesIPdirectedbroadcastglobally.
Syntax
ip directed-broadcast
no ip directed-broadcast
Parameters
None.
Defaults
None.
Mode
Interfaceconfiguration:C3(su)‐>Router1(Config‐if(Vlan1))#
Example
ThisexampleshowshowtoenableIPdirectedbroadcastsonVLAN1:
C3(su)->router(Config)#interface vlan 1
C3(su)->router(Config-if(Vlan 1))#ip directed-broadcast
For information about... Refer to page...
ip directed-broadcast 15-17
ip helper-address 15-18