Specifications

SecureStack C3 Configuration Guide 15-1
15
IP Configuration
ThischapterdescribestheInternetProtocol(IP)configurationsetofcommandsandhowtouse
them.
Configuring Routing Interface Settings
Purpose
Toenableroutinginte rfaceconfigurationmodeonthedevice,tocreateroutinginterfaces,to
reviewtheusabilitystatusofinterfacesconfiguredforIP,tosetIPaddressesforinterfaces,to
enableinterfacesforIProutingatdevicestartup,andtoreviewtherunningconfiguration.
Commands
Thecommandsusedtoreviewandconfigureinterfacesettingsarelistedbelow:
Router: Unless otherwise noted, the commands covered in this chapter can be executed only
when the device is in router mode. For details on how to enable router configuration modes, refer
to “Enabling Router Configuration Modes” on page 14-3.
For information about... Refer to page...
Configuring Routing Interface Settings 15-1
Configuring Tunnel Interfaces 15-8
Reviewing and Configuring the ARP Table 15-12
Configuring Broadcast Settings 15-17
Reviewing IP Traffic and Configuring Routes 15-19
Note: For information about configuring tunnel interfaces, see “Configuring Tunnel Interfaces” on
page 15-8.
For information about... Refer to page...
show interface 15-2
interface 15-3
show ip interface 15-4
ip address 15-5