Specifications

Enabling Router Configuration Modes
SecureStack C3 Configuration Guide 14-3
Enabling Router Configuration Modes
TheSecureStackC3CLIprovidesdifferentmodesofrouteroperationforissuingasubsetof
commandsfromeachmode.Table 14‐2describesthesemodesofoperation.
Table 14-2 Router CLI Configuration Modes
Use this mode... To... Access method... Resulting Prompt...
Privileged EXEC
Mode
Set system operating
parameters
Show configuration
parameters
Save/copy
configurations
From the switch CLI:
Type router, then
Type enable.
C3(su)->router>
C3(su)->router#
Global Configuration
Mode
Set system-wide
parameters.
Type configure from
Privileged EXEC mode.
C3(su)->router (Config)#
Interface
Configuration Mode
Configure router
interfaces.
Type interface vlan or
loopback and the
interface’s id from Global
Configuration mode.
C3(su)->router(Config-if
(Vlan 1))#
C3(su)->router(Config-if
(Lpbk 1))#
Router Configuration
Mode
Set IP protocol
parameters.
Type router and the
protocol name (and, for
OSPF, the instance ID)
from Global or Interface
Configuration mode.
C3(su)->router(Config-router)#
Note: To jump to a lower configuration mode, type exit at the command prompt. To revert back to
switch CLI, type exit from Privileged EXEC router mode.