Specifications

Configuring General DHCP Server Parameters
SecureStack C3 Configuration Guide 13-3
Configuring General DHCP Server Parameters
Purpose
ToconfigureDHCPserverparameters,andtodisplayandclearaddressbindinginformation,
serverstatistics,andconflictinformation.
Commands
CommandstoconfigureDHCPserverparametersandtodisplayandclearDHCPserver
informationarelistedbelow.
set dhcp
UsethiscommandtoenableordisabletheDHCPserverfunctionalityontheSecureStackC3.
Syntax
set dhcp {enable | disable}
Parameters
Defaults
None.
Mode
Switchcommand,read‐write.
For information about... Refer to page...
set dhcp 13-3
set dhcp bootp 13-4
set dhcp conflict logging 13-4
show dhcp conflict 13-5
clear dhcp conflict 13-5
set dhcp exclude 13-6
clear dhcp exclude 13-7
set dhcp ping 13-7
clear dhcp ping 13-8
show dhcp binding 13-8
clear dhcp binding 13-9
show dhcp server statistics 13-9
clear dhcp server statistics 13-10
enable|disable EnableordisableDHCPserverfunctionality.Bydefault,DHCPserveris
disabled.