Specifications

Filter Group Commands
SecureStack C3 Configuration Guide 12-19
Filter Group Commands
Thepacketcaptureandfilterfunctionisdisabledbydefault.Whenitisenabled,theSecureStack
C3switchwillcapture100framesasclosetosequentiallyaspossible.These100frameswillbe
placedintoabufferforinspection.Ifthereisdatainthebufferwhenthefunctionisst arted,
the
bufferwillbeoverwritten.Once100frameshavebeencaptured,thecapturewillstop.Filtering
willbeperformedontheframescapturedinthebuffer.
Onechannelatatimecanbesupported,withuptothreefilters.Configuredchannel,filter,and
buffercontrolinformationwillbesavedacross
resets,butcapturedframeswillnot.
Thisfunctioncannotbeusedconcurrentlywithportmirroring.Thesystemwillchecktoprevent
concurrentlyenablingbothfunctions,andawarningwillbegeneratedintheCLIifattempted.
Commands
show rmon channel
UsethiscommandtodisplayRMONchannelentriesforoneormoreports.
Syntax
show rmon channel [port-string]
Parameters
Defaults
Ifport‐stringisnotspecified,informationaboutallchannelswillbedisplayed.
Mode
Switchcommand,read‐only.
Example
ThisexampleshowshowtodisplayRMONchannelinformationforfe.2.12:
Note: Packet capture filter is sampling only and does not guarantee receipt of back to back
packets.
For information about... Refer to page...
show rmon channel 12-19
set rmon channel 12-20
clear rmon channel 12-21
show rmon filter 12-21
set rmon filter 12-22
clear rmon filter 12-23
port‐string (Optional)DisplaysRMONchannelentriesforaspecificport(s).