Specifications

Using the Command Line Interface
SecureStack C3 Configuration Guide 1-7
Figure 1-1 SecureStack C3 Startup Screen
Connecting Using Telnet
OncetheSecureStackC3devicehasavalidIPaddress,youcanestablishaTelnetsessionfromany
TCP/IPbasednodeonthenetwork.Forinformationaboutsettingtheswitch’sIPaddress,referto
“setipaddress”onpage 3‐10.
ToestablishaTelnetsession:
1. Telnettotheswitch’sIPaddress.

2. Enterlogin(username)andpasswordinformationinoneofthefollowingways:
–Iftheswitch’sdefaultloginandpasswordsettingshavenotbeenchanged,followthe
stepslistedin“UsingaDefaultUserAccount”onpage 1‐7,or
–Enteranadministratively‐configuredusernameandpassword.
Thenoticeofauthorization
andthepromptdisplaysasshowninFigure 1‐1.
ForinformationaboutconfiguringTelnetsettings,referto “StartingandConfiguringTelnet”on
page 3‐43.
RefertotheinstructionsincludedwiththeTelnetapplicationforinformationaboutestablishinga
Telnetsession.
Logging In
Bydefault,theSecureStackC3switchisconfiguredwiththreeuserloginaccounts—rofor
Read‐Onlyaccess,rwforRead‐Writeaccess,andadminforsuper‐useraccesstoallmodifiable
parameters.Thedefaultpasswordissettoablankstring.Forinformationonchangingthese
defaultsettings,referto
“SettingUserAccountsandPasswords”onpage 3‐2.
Using a Default User Account
IfthisisthefirsttimeyouareloggingintotheSecureSt ackC3switch,orifthedefaultuser
accountshavenotbeenadministrativelychanged,proceedasfollows:
Username:admin
Password:
Enterasys SecureStack C3
Command Line Interface
Enterasys Networks, Inc.
50 Minuteman Rd.
Andover, MA 01810-1008 U.S.A.
Phone: [phone]
E-mail: [e-mail]
WWW: http://www.enterasys.com
(c) Copyright Enterasys Networks, Inc. 2006
Chassis Serial Number: 041800249041
Chassis Firmware Revision: 1.00.xx
C3(su)->