Specifications

Using the Command Line Interface
1-6 Introduction
Using the Command Line Interface
Starting a CLI Session
Connecting Using the Console Port
ConnectaterminaltothelocalconsoleportasdescribedinyourSecureStackC3InstallationGuide.
Thestartupscreen,Figure 1‐1,willdisplayontheterminal.YoucannowstarttheCommandLine
Interface(CLI)by
•usingadefaultuseraccount,asdescribedin“UsingaDefaultUserAccount”
onpage 1 ‐7,or
•usinganadministratively‐assigneduseraccountasdescribedin“UsinganAdministratively
ConfiguredUserAccount”onpage 1‐8.
Retransmit delay (OSPF) Set to 1 second.
Retransmit interval (OSPF) Set to 5 seconds.
RIP receive version Set to accept both version 1 and version 2.
RIP send version Set to version 1.
RIP offset No value applied.
SNMP Enabled.
Split horizon Enabled for RIP packets without poison reverse.
Stub area (OSPF) None configured.
Telnet Enabled.
Telnet port (IP) Set to port number 23.
Timers (OSPF) SPF delay set to 5 seconds. SPF holdtime set to 10 seconds.
Transmit delay (OSPF) Set to 1 second.
VRRP Disabled.
Table 1-2 Default Settings for Router Operation (Continued)
Feature Default Setting