Specifications

show users
SecureStack C3 Configuration Guide 11-15
show users
UsethiscommandtodisplayinformationabouttheactiveconsoleportorTelnetsession(s)logged
intotheswitch.
Syntax
showusers
Parameters
None.
Defaults
None.
Mode
Switchcommand,read‐only.
Example
Thisexampleshowshowtousetheshowuserscommand.Inthisoutput,therearetwoTelnet
usersloggedinwithRead‐WriteaccessprivilegesfromIPaddresses134.141.192.119and
134.141.192.18:
C3(su)->show users
Session User Location
-------- ----- --------------------------
* telnet rw 134.141.192.119
telnet rw 134.141.192.18
disconnect
UsethiscommandtocloseanactiveconsoleportorTelnetsessionfromtheswitchCLI.
Syntax
disconnect{ip‐addr|console}
Parameters
Defaults
None.
Mode
Switchcommand,read‐write.
ip‐addr SpecifiestheIPaddressoftheTelnetsessiontobedisconnected.This
addressisdisplayedintheoutputshownin“showusers”onpage 12‐15.
console Closesanactiveconsoleport.