Specifications

show logging server
11-2 Logging and Network Management
show logging server
UsethiscommandtodisplaytheSyslogconfigurationforaparticularserver.
Syntax
show logging server [index]
Parameters
Defaults
Ifindexisnotspecified,allSyslogserverinformationwillbedisplayed.
Mode
Switchcommand,read‐only.
Example
ThisexampleshowshowtodisplaySyslogserverconfigurationinformation:
C3(ro)->show logging server
IP Address Facility Severity Description Port Status
-------------------------------------------------------------------------
1 132.140.82.111 local4 warning(5) default 514 enabled
2 132.140.90.84 local4 warning(5) default 514 enabled
Table 11‐1providesanexplanationofthecommandoutput.
set logging application 11-8
clear logging application 11-9
show logging local 11-9
set logging local 11-10
clear logging local 11-10
show logging buffer 11-11
For information about... Refer to page...
index (Optional)DisplaysSysloginformationpertainingtoaspecificserver
tableentry.Validvaluesare1‐8.
Table 11-1 show logging server Output Details
Output What It Displays...
IP Address Syslog server’s IP address. For details on setting this using the set logging server
command, refer to “set logging server” on page 11-3.
Facility Syslog facility that will be encoded in messages sent to this server. Valid values are:
local0 to local7.
Severity Severity level at which the server is logging messages.
Description Text string description of this facility/server.