Specifications

SecureStack C3 Configuration Guide 11-1
11
Logging and Network Management
Thischapterdescribesswitch‐relatedloggingandnetworkmanagementcommandsandhowto
usethem.
Configuring System Logging
Purpose
Todisplayandconfiguresystemlogging,includingSyslogserversettings,Syslogdefaultsettings,
andtheloggingbuffer.
Commands
Commandstoconfiguresystemloggingarelistedbelow.
Note: The commands in this chapter pertain to network management of the SecureStack C3
device from the switch CLI only. For information on router-related network management tasks,
including reviewing router ARP tables and IP traffic, refer to Chapter 15.
For information about... Refer to page...
Configuring System Logging 11-1
Monitoring Network Events and Status 11-12
Managing Switch Network Addresses and Routes 11-17
Configuring Simple Network Time Protocol (SNTP) 11-27
Configuring Node Aliases 11-34
For information about... Refer to page...
show logging server 11-2
set logging server 11-3
clear logging server 11-4
show logging default 11-4
set logging default 11-5
clear logging default 11-6
show logging application 11-7