Specifications

Switch Management Methods
1-2 Introduction
Switch Management Methods
TheSecureStackC3switchcanbemanagedusingthefollowingmethods:
•LocallyusingaVTtypeterminalconnectedtotheconsoleport.
• RemotelyusingaVTtypetermina lconnectedthroughamodem.
• RemotelyusinganSNMPmanagementstation.
•In‐bandthroughaTelnetconnection.
•In‐bandusingEnterasysNetworks’NetSight
®
managementapplication.
• RemotelyusingWebView™,EnterasysNetworks’embeddedwebserverapplication.
TheInstallationGuideforyourSecureStackC3deviceprovidessetupinstructionsforconnectinga
terminalormodemtotheswitch.
Factory Default Settings
ThefollowingtableslistfactorydefaultsettingsavailableontheSecureStackC3switch.Table 1‐1
listsdefaultsettingsforSecureStackC3switchoperation.Table 1‐2listsdefaultsettingsforrouter
modeoperation.
Table 1-1 Default Settings for Basic Switch Operation
Feature Default Setting
CDP discovery protocol Auto enabled on all ports.
CDP authentication code Set to 00-00-00-00-00-00-00-00
CDP hold time Set to 180 seconds.
CDP interval Transmit frequency of CDP messages set to 60 seconds.
Cisco discovery protocol Auto enabled on all ports.
Cisco DP hold time Set to 180 seconds.
Cisco DP interval timer Set to 60 seconds.
Community name Public.
Console (serial) port
required settings
Baud rate: 9600
Data bits: 8
Flow control: disabled
Stop bits: 1
Parity: none
DHCP server Disabled.
EAPOL Disabled.
EAPOL authentication
mode
When enabled, set to auto for all ports.
GARP timer Join timer set to 20 centiseconds; leave timer set to 60 centiseconds; leaveall
timer set to 1000 centiseconds.
GVRP Globally enabled.
History buffer size 20 lines.
IEEE 802.1 authentication Disabled.