Specifications

Creating and Naming Static VLANs
SecureStack C3 Configuration Guide 7-5
Creating and Naming Static VLANs
Purpose
TocreateanewstaticVLAN,ortoenableordisableexistingVLAN(s).
Commands
ThecommandsusedtocreateandnamestaticVLANsarelistedbelow.
set vlan
UsethiscommandtocreateanewstaticIEEE802.1QVLAN,ortoenableordisableanexisting
VLAN.
Syntax
set vlan {create | enable | disable} vlan-list
Parameters
Defaults
None.
Mode
Switchcommand,read‐write.
Usage
OnceaVLANiscreated,youcanassignitanameusingthesetvlannamecommanddescribedin
“setvlanname”onpage 7‐6.
EachVLANIDmustbeunique.IfaduplicateVLANIDisentered,thedeviceassumesthatthe
AdministratorintendstomodifytheexistingVLAN.
Enter
theVLANIDusingauniquenumberbetween1and4093.TheVLANIDsof0and4094and
highermaynotbeusedforuser‐definedVLANs.
For information about... Refer to page...
set vlan 7-5
set vlan name 7-6
clear vlan 7-6
clear vlan name 7-7
create|enable|
disable
Creates,enablesordisablesVLAN(s).
vlan‐list SpecifiesoneormoreVLANIDstobecreated,enabledordisabled.