Specifications

set newaddrtrap
SecureStack C3 Configuration Guide 5-35
set newaddrtrap
UsethiscommandtoenableordisableSNMPtrap messaging,globallyorononeormoreports,
whennewsourceMACaddressesaredetected.
Syntax
set newaddrtrap [port-string] { enable | disable }
Parameters
Defaults
Ifport‐stringisnotspecified,thetrapfunctionissetglobally.
Mode
Switchmode,read‐write.
Usage
ThiscommandenablesanddisablessendingSNMPtrapmessageswhenanewsourceMAC
addressisdetectedbyaport.Iftheportisa CDPport,however,trapsfornewsourceMAC
addresseswillnotbesent.
Thedefaultmodeisdisabledgloballyandperport.
Example
ThisexampleenablesthetrapfunctiongloballyandthenonGigabitEthernetports1through5on
unit1.
C3(rw)->set newaddrtrap enable
C3(rw)->set newaddrtrap ge.1.1-5 enable
port‐string (Optional)EnableordisablethenewMACaddressestrapfunctionon
specificports.
enable|disable EnableordisablethenewMACaddressestrapfunction.Ifentered
withouttheport‐stringparameter,enablesordisablethefunction
globally.Whenenteredwiththeport‐stringparameter,enablesor
disablesthefunction
onspecificports.