Specifications

Configuring SNMP Target Addresses
SecureStack C3 Configuration Guide 5-29
Configuring SNMP Target Addresses
Purpose
ToreviewandconfigureSNMPtargetaddresseswhichwillreceiveSNMPnotificationmessages.
AnaddressconfigurationcanbelinkedtooptionalSNMPtransmit,ortarget,parameters(suchas
timeout,retrycount,andUDPport)setwiththesetsnmptargetparamscommand((page5‐27)).
Commands
ThecommandsusedtoreviewandconfigureSNMPtargetaddressesarelistedbelow.
show snmp targetaddr
UsethiscommandtodisplaySNMPtargetaddressinformation.
Syntax
show snmp targetaddr [targetAddr] [volatile | nonvolatile | read-only]
Parameters
Defaults
IftargetAddrisnotspecified,entriesforalltargetaddressnameswillbedisplayed.
Ifnotspecified,entriesofallstoragetypeswillbedisplayedforatargetaddress.
Mode
Switchcommand,read‐only.
Example
ThisexampleshowshowtodisplaySNMPtargetaddressinformation:
C3(su)->show snmp targetaddr
Target Address Name = labmachine
Tag List = v2cTrap
IP Address = 10.2.3.116
UDP Port# = 162
Target Mask = 255.255.255.255
Timeout = 1500
Retry count = 4
For information about... Refer to page...
show snmp targetaddr 5-29
set snmp targetaddr 5-30
clear snmp targetaddr 5-31
targetAddr (Optional)Displaysinformationforaspecifictargetaddressname.
volatile|nonvolatile
|read‐only
(Optional)Whentargetaddressisspecified,displaystargetaddress
informationforaspecificstoragetype.