Specifications

set lacp singleportlag
SecureStack C3 Configuration Guide 4-47
Defaults
None.
Mode
Switchcommand,read‐write.
Example
Thisexampleshowshowtoremovefe.1.6fromtheLAGofaggregatorport6:
C3(su)->clear lacp static lag.0.6 fe.1.6
set lacp singleportlag
UsethiscommandtoenableordisabletheformationofsingleportLAGs.
Syntax
set lacp singleportlag {enable | disable}
Parameters
Defaults
None.
Mode
Switchcommand,read‐write.
Usage
WhensingleportLAGsareenabled,LAGsaremaintainedwhenonlyoneport isreceiving
protocoltransmissionsfromapartner.IfsingleportLAGsarenotenabledandaLAGgoesdown
tooneport,theLAG(lag.x.x)willnotbeusedbutinsteadtheport’ssyntaxwillbeused(for

example,fe.3.24).ThiscouldcauseproblemsiftheLAGandtheporthavedifferentconfigurations
(theLAGandtheportmayhavedifferentVLANorPolicyconfigurations).
Example
ThisexampleshowshowtoenablesingleportLAGs:
C3(su)->set lacp singleportlag enable
disable|enable EnablesordisablestheformationofsingleportLAGs.