Specifications

show lacp
4-42 Port Configuration
Parameters
Defaults
Ifport‐stringisnotspecified,linkaggregationinformationforallLAGswillbedisplayed.
Mode
Switchcommand,read‐only.
Usage
EachSecureStackC3moduleprovides6virtuallinkaggregatorports,whicharedesignatedinthe
CLIaslag.0.1throughlag.0.6.Onceunderlyingphysicalports(thatis,fe.x.x,ge.x.x)areassociated
withanaggregatorport,theresultingaggregationwillberepresentedasoneLinkAggregation
Group(LAG)withalag.x.x
portdesignation.
Example
Thisexampleshowshowtodisplaylacpinformationforlag.0.1:
C3(su)->show lacp lag.0.1
Global Link Aggregation state: enabled
Single Port LAGs: disabled
Aggregator: lag.0.1
Actor Partner
System Identifier: 00:01:F4:5F:1E:20 00:11:88:11:74:F9
System Priority: 32768 32768
Admin Key: 32768
Oper Key: 32768 0
Attached Ports: ge.1.1
ge.1.3
Table 4‐6providesanexplanationofthecommandoutput.
port‐string (Optional)DisplaysLACPinformation forspecificLAGport(s).Valid
portdesignationsarelag.0.1‐6.
Table 4-6 show lacp Output Details
Output What It Displays...
Global Link
Aggregation state
Shows if LACP is enabled or disabled on the switch.
Single Port LAGs Displays if the single port LAG feature has been enabled on the switch. See “set lacp
singleportlag” on page 4-47 for more about single port LAG.
Aggregator LAG port designation. Each SecureStack C3 module provides 6 virtual link
aggregator ports, which are designated in the CLI as lag.0.1 through lag.0.6. Once
underlying physical ports (for example, fe.x.x, ge.x.x) are associated with an
aggregator port, the resulting Link Aggregation Group (LAG) is represented with a
lag.x.x port designation.
Actor Local device participating in LACP negotiation.
Partner Remote device participating in LACP negotiation.
System Identifier MAC addresses for actor and partner.