Specifications

clear mirror vlan
4-38 Port Configuration
Example
ThefollowingexampleassignsaVLANformirroringtrafficandthenshowstheconfiguredport
mirroringwiththeshowportmirrorcommand.
C3(su)->set mirror vlan 2
C3(su)->show port mirroring
Port Mirroring
==============
Source Port = ge.1.1
Target Port = ge.1.10
Frames Mirrored = Rx and Tx
Port Mirroring status enabled
Mirror Vlan = 2
clear mirror vlan
UsethiscommandtocleartheVLANtobereservedformirroringtraffic.
Syntax
clear mirror vlan vlan-id
Parameters
Defaults
None.
Mode
Switchcommand,read‐write.
Example
ThefollowingexampleclearsVLAN2frombeingusedforremoteportmirroring.
C3(su)->clear mirror vlan 2
Link Aggregation Control Protocol (LACP)
Usingmultiplelinkssimultaneouslytoincreasebandwidthisadesirableswitchfeature,which
canbeaccomplishedifbothsidesagreeonasetofportsthatarebeingusedasaLinkAggregation
Group(LAG).OnceaLAGisformedfromselectedports,problemswithloopingcanbeavoided
sincethe
SpanningTreecantreatthisLAGasasingleport.
Enabledbydefault,theLinkAggregationControlProtocol(LACP)logicallygroupsinterfaces
togethertocreateagreaterbandwidthuplink,orlinkaggregation,accordingtotheIEEE802.3ad
standard.ThisstandardallowstheswitchtodeterminewhichportsareinLAGsand
configure
vlan‐id SpecifiestheVLANtobecleared.TheIDcanrangefrom2to4093.
Caution: Link aggregation configuration should only be performed by personnel who are
knowledgeable about Spanning Tree and Link Aggregation, and fully understand the ramifications
of modifications beyond device defaults. Otherwise, the proper operation of the network could be
at risk.