Specifications

Setting Flow Control
SecureStack C3 Configuration Guide 4-19
Setting Flow Control
Purpose
Toreview,enableordisableportflowcontrol.Flowcontrolisusedtomanagethetransmission
betweentwodevicesasspecifiedbyIEEE 802.3xtopreventreceivingportsfrombeing
overwhelmedbyframesfromtransmittingdevices.
Commands
Thecommandsusedtoreviewandsetportflowcontrolarelistedbelow:
show flowcontrol
Usethiscommandtodisplaytheflowcontrolstate.
Syntax
show flowcontrol
Parameters
None.
Defaults
None.
Mode
Switchcommand,read‐only.
Example
Thisexampleshowshowtodisplaytheportflowcontrolstate:
C3(su)->show flowcontrol
Flow control status: enabled
For information about... Refer to page...
show flowcontrol 4-19
set flowcontrol 4-20