Specifications

Enabling / Disabling Jumbo Frame Support
4-12 Port Configuration
Defaults
None.
Mode
Switchcommand,read‐write.
Example
ThisexampleshowshowtosetFastEthernetport17inunit1tofullduplex:
C3(su)->set port duplex fe.1.17 full
Enabling / Disabling Jumbo Frame Support
Purpose
Toreview,enable,anddisablejumboframesupportononeormoreports.ThisallowsGigabit
Ethernetportstotransmitframesupto10KBinsize.
Commands
Thecommandsusedtoreview,enableanddisablejumboframesupportarelistedbelow.
show port jumbo
Usethiscommandtodisplaythestatusofjumboframesupportandmaximumtransmissionunits
(MTU)ononeormoreports.
Syntax
show port jumbo [port-string]
Parameters
Defaults
Ifport‐stringisnotspecified,jumboframesupportstatusforallportswilldisplay.
Mode
Switchcommand,read‐only.
For information about... Refer to page...
show port jumbo 4-12
set port jumbo 4-14
clear port jumbo 4-14
port‐string (Optional)Displaysthestatusofjumboframesupportforspecific
port(s).Foradetaileddescriptionofpossibleport‐stringvalues,referto
“PortStringSyntaxUsedintheCLI”onpage4‐1.