Specifications

Reviewing Port Status
4-2 Port Configuration
Portnumbercanbe:
1–48fortheC3G124‐48andC3G124‐48P
1–24fortheC3G124‐24,C3G134‐24P
Thehighestvalidportnumberisdependentonthenumberofportsinthedeviceandtheport
type.
Examples
Thisexampleshowstheport‐stringsyntaxforspecifyingthe100‐MbpsEthernetports1through10
inunit1inthestack.
fe.1.1-10
Thisexampleshowstheport‐stringsyntaxforspecifyingthe1‐GigabitEthernetport14inunit3in
thestack
.
ge.3.14
Thisexampleshowstheport‐stringsyntaxforspecifyingthefirst10‐GigabitEthernetportofunit3
inthestack.
tg.3.25
Thisexampleshowstheport‐stringsyntaxforspecifyingall1‐GigabitEthernetportsinunit3in
thestack.
ge.3.*
Thisexampleshowstheport‐stringsyntaxforspecifyingallports(ofanyinterfacetype)inallunits
inthestack.
*.*.*
Reviewing Port Status
Purpose
Todisplayoperatingstatus,duplexmode,speed,porttype,andstatisticalinformationabout
trafficreceivedandtransmittedthroughoneorallswitchportsonthedevice.
Commands
Thecommandsusedtoreviewportstatusarelistedbelow.
Note: You can use a wildcard (*) to indicate all of an item. For example, fe.3.* would represent all
100Mbps Ethernet (fe) ports in unit 3 in the stack.
For information about... Refer to page...
show port 4-3
show port status 4-4
show port counters 4-5