Specifications

SecureStack C3 Configuration Guide 4-1
4
Port Configuration
ThischapterdescribesthePortConfigurationsetofcommandsandhowtousethem.
Port Configuration Summary
Port String Syntax Used in the CLI
Commandsrequiringaport‐stringparameterusethefollowingsyntaxtodesignateporttype,slot
location,andportnumber:
porttype.unitnumber.portnumber
Whereporttypecanbe:
fefor100‐MbpsEthernet
gefor1‐GbpsEthernet
tgfor10‐GbpsEthernet
hostforthehostport
vlanforvlaninterfaces
lagfor
IEEE802.3linkaggregationports
Unitnumbercanbe:
1‐8forswitchunitsinaSecureStackC3stack
For information about... Refer to page...
Port Configuration Summary 4-1
Reviewing Port Status 4-2
Disabling / Enabling and Naming Ports 4-6
Setting Speed and Duplex Mode 4-9
Enabling / Disabling Jumbo Frame Support 4-12
Setting Auto-Negotiation and Advertised Ability 4-15
Setting Flow Control 4-19
Setting Port Link Traps and Link Flap Detection 4-20
Configuring Broadcast Suppression 4-30
Port Mirroring 4-33
Link Aggregation Control Protocol (LACP) 4-38
Configuring Protected Ports 4-53