Specifications

Using and Configuring WebView
SecureStack C3 Configuration Guide 3-71
Using and Configuring WebView
Purpose
Bydefault,WebView(TheEnterasysNetworksembeddedwebserverforswitchconfiguration
andmanagementtasks)isenabledonTCPportnumber80ontheSecureStackC3switch.Youcan
verifyWebViewstatus,andenableordisableWebViewusingthecommandsdescribedinthis
section.WebViewcanalsobesecurelyusedover
SSLport443,ifSSLisenabledontheswitch.By
default,SSLisdisabled.
TouseWebView,typetheIPaddressoftheswitchinyourbrowser.TouseWebViewoverSSL,
typeinhttps://thentheIPaddressoftheswitch.Forexample,https://172.16.2.10.
Commands
ThecommandstoconfigureWebViewandSSLaredescribedbelow.
show webview
UsethiscommandtodisplayWebViewstatus.
Syntax
show webview
Parameters
None.
Defaults
None.
Mode
Switchcommand,read‐only.
Example
ThisexampleshowshowtodisplayWebViewstatus:
C3(rw)->show webview
WebView is Enabled.
For information about... Refer to page...
show webview 3-71
set webview 3-72
show ssl 3-72
set ssl 3-73