Specifications

Resetting the Switch
SecureStack C3 Configuration Guide 3-69
Resetting the Switch
Purpose
Toresetoneormoreswitches,andtocleartheuser‐definedconfigurationparameters.
Commands
Thecommandsusedtoresettheswitchandcleartheconfigurationarelistedbelow.
reset
Usethiscommandtoresettheswitchwithoutlosinganyuser‐definedconfigurationsettings.
Syntax
reset [unit]
Parameters
Defaults
If no unit ID is specified, the entire system will be reset.
Mode
Switchcommand,read‐write.
Usage
ASecureStackC3switchcanalsoberesetwiththeRESETbuttonlocatedonitsfrontpanel.For
informationonhowtodothis,refertotheSecureStackC3InstallationGuideshippedwithyour
switch.
Examples
Thisexampleshowshowtoresetthesystem:
C3(su)->reset
Are you sure you want to reload the stack? (y/n) y
Saving Configuration to stacking members
Reloading all switches.
Thisexampleshowshowtoresetunit1inthe stack:
C3(su)->reset 1
Are you sure you want to reload the switch? (y/n) y
For information about... Refer to page...
reset 3-69
clear config 3-70
unit (Optional)Specifiesaunittobereset.