Specifications

set ciscodp port
3-64 Basic Configuration
set ciscodp port
Usethiscommandtosetthestatus,voiceVLAN,extendedtrustmode,andCoSpriorityfor
untrustedtrafficfortheCiscoDiscoveryProtocolononeormoreports.
Syntax
set ciscodp port { [status {disable | enable}] [ vvid {vlan-id | none | dot1p |
untagged}] [trusted {yes | no}] [cos value] } port-string
Parameters
Defaults
Status:enabled
VoiceVLAN:none
Trustmode:trusted
CoSvalue:0
Mode
Switchmode,read‐write.
Usage
ThefollowingpointsdescribehowtheCiscoDPextendedtrustsettingsworkontheswitch.
•ACiscoDPporttruststatusoftrustedoruntrustedisonlymeaningfulwhenaCiscoIPphone
isconnectedtoaswi tchportandaPCorotherdeviceisconnectedtothebackof
theCiscoIP
phone.
status SettheCiscoDPportoperationalstatus.
disable DonottransmitorprocessCiscoDPPDUs.
enable TransmitandprocessCiscoDPPDUs.
vvid SettheportvoiceVLANforCiscoDPPDUtransmission.
vlan‐id SpecifytheVLANID,range1‐4094.
none NovoiceVLANwillbeusedinCiscoDPPDUs.Thisis
thedefault.
dot1p Instructattachedphonetosend802.1ptaggedframes.
untagged Instructattachedphonetosenduntaggedframes.
trusted Settheextendedtrustmodeontheport.
yes Instructattachedphonetoallowthedeviceconnectedtoittotransmit
trafficcontaininganyCoSorLayer2802.1pmarking.Thisisthedefault
value.
no Instructattachedphonetooverwritethe802.1ptagoftraffic
transmittedbythedeviceconnectedtoitto0,bydefault,ortothevalue
configuredwiththecosparameter.
cosvalue Instructattachedphonetooverwritethe802.1ptagoftraffic
transmittedbythedeviceconnectedtoitwith
thespecifiedvalue,when
thetrustmodeoftheportissettountrusted.Valuecanrangefrom0to
7,with0indicatingthelowestpriority.
port‐string Specifiestheport(s)onwhichstatuswillbeset.