Specifications

Starting and Configuring Telnet
SecureStack C3 Configuration Guide 3-43
Starting and Configuring Telnet
Purpose
ToenableordisableTelnet,andtostartaTelnetsessiontoaremotehost.TheSecureStackC3 
switchallowsatotaloffourinboundand/oroutboundTelnetsessiontorunsimultaneously.
Commands
Thecommandsusedtoenable,startandconfigureTelnetarelistedbelow.
show telnet
UsethiscommandtodisplaythestatusofTelnetontheswitch.
Syntax
show telnet
Parameters
None.
Defaults
None.
Mode
Switchcommand,read‐only.
Example
ThisexampleshowshowtodisplayTelnetstatus:
C3(su)->show telnet
Telnet inbound is currently: ENABLED
Telnet outbound is currently: ENABLED
For information about... Refer to page...
show telnet 3-43
set telnet 3-44
telnet 3-44