Installation guide

Installing Optional Mini-GBICs

Hardware Installation 3-3

To prepare and install a Mini-GBIC, proceed as follows:

Preparation

Before installing the Mini-GBIC, proceed as follows:

1. Attach the antistatic wrist strap (refer to the instructions in the antistatic wrist strap package)

before removing the Mini-GBIC from the antistatic packaging.

2. Remove the Mini-GBIC from the packaging.

3. If there is a protective dust cover (see Figure 3-1,

) on the Mini-GBIC port, do not remove it

at this time.

Installation

To install a Mini-GBIC, refer to Figure 3-1 or Figure 3-2, and proceed as follows:

1. Hold the Mini-GBIC

with its top side facing up and its 7-pin edge connector facing the

port slot

2. Carefully align the Mini-GBIC

with the port slot .

3. Push the Mini-GBIC

into the port slot until the Mini-GBIC “clicks” and locks into place.

Figure 3-1 Mini-GBIC with MT-RJ Connector (C1H124-48 shown)

Mini-GBIC (MGBIC-MT01)

Port slot

Mini-GBIC, top side

Mini-GBIC, protective dust cover

7-Pin edge connector (insertion side)

Release tab

3831_01_02

CPU RPS 149

250 52