Installation guide

Hardware Installation 3-1

Hardware Installation

This chapter provides the instructions required to install the device. Follow the order of the sections

as listed below to correctly install the device.

• Unpacking the device (Section 3.2)

• Installing options (Section 3.3)

• Installing the device (on a shelf or tabletop, or into a standard rack) (Section 3.4)

• Connecting to the network (Section 3.5)

• Connecting to console port for local management (Section 3.6)

• Completing the installation (Section 3.7)

3.1 REQUIRED TOOLS

A Phillips screwdriver is required to install the device into a rack.

ELECTRICAL HAZARD: Only qualified personnel should install the C1H124-48 and

C1G124-24.

NOTE: Read the Release Notes shipped with the C1H124-48 and C1G124-24 to check

for any exceptions to the supported features and operation documented in this guide.