Specifications

Enterasys Wireless Controller Software CLI Reference Guide 22-1
22
Location Commands (lbs)
ThissectiondescribescommandsusedtoenableandconfigureanAeroScoutlocationbased
serviceonaEnterasysWirelessControllerandWirelessAPs.Thesecommandsarelocatedinthe
lbscontextoftheCLI.Executethelbscommandattherootleveltoenterlbscontext.
Thefollowingcommandsareavailablein
thelbscontext:
• service
• server‐ip
• show
Forinformationonrelatedcommandsthatareavailableinothercontexts,see“Related
commands”onpage 22‐2.
22.1 service
UsetheservicecommandtoenableordisabletheAeroScoutlocationbasedserviceonthe
EnterasysWirelessController.TheservicecommandisaccessiblefromthelbscontextoftheCLI.
Syntax
service enable|disable
Parameters
Usage
Youmustalsousetheserver‐ipcommandspecifytheIPaddressoftheAeroScoutserver.
Examples
ThefollowingexampleenablestheAeroScoutlocationbasedservice.
EWC.enterasys.com:lbs# service enable
Note: All CLI commands cache changes. For this reason, sometimes when you make a change in a
particular context, the change may not be visible immediately. If this happens, you must exit and re-
enter the context in order to ensure that the database is synchronized with the latest change.
enable|disable Specifiesthenameofthetopology.