Specifications

21-30 topology Commands
21.4.3.15 show
UsetheshowcommandtodisplayLayer3information.Theshowcommandisavailablefromthe
topology:<named‐topology>:l3contextoftheCLIforadmin,b@ac,physical,androuted
topologies.
Syntax
show
Parameters
None
Examples
ThefollowingexampledisplaysLayer3informationforaphysicaltopology.
EWC.enterasys.com:topology:esa0:l3# show
Interface IP 10.109.0.1 255.255.255.0
AP Registration: enable
Allow management traffic: disable
Factory default certificate/key
MTU: 1500
ThefollowingexampledisplaysLayer3informationforab@actopology.
EWC.enterasys.com:topology:bridged_ac1:l3# show
Interface IP 0.0.0.0 0.0.0.0
AP Registration: disable
Allow management traffic: disable
Factory default certificate/key
Strict Subnet Adherence: enable
MTU: 1436
21.4.4 l3presence
Usethel3presencecommandtoenableordisableLayer3onab@actopology.Thel3presence
commandisavailablefromthetopology:<named‐topology>contextoftheCLIforb@ac
topologies.
Syntax
l3presence enable | disable
Parameters
Note: After you run the ospf-cost command, you must run the apply command to implement the
changes.
Note: You must enable Layer 3 on a b@ac topology to access Layer 3 commands in the
topology:<named-topology>:l3 context.
enable EnablesLayer3.