Specifications

21-18 topology Commands
Examples
Thefollowingexamplesetsthedefaultleasetimeto34000seconds.
EWC.enterasys.com:topology:routed2:l3:dhcp# mode local
EWC.enterasys.com:topology:routed2:l3:dhcp# lease 34000
EWC.enterasys.com:topology:routed2:l3:dhcp# apply
21.4.3.4.11 lease-max
Usethelease‐maxcommandtosetthemaximumtimelimit,inseconds,thatanIPaddresswould
beassignedbytheDHCPservertoawirelessdevice.Thelease‐maxcommandisavailablefrom
thetopology:<named‐topology>:l3:dhcpcontextoftheCLIforb@ac,physical,androuted
topologies.Thiscommandis
visibleonlywhenmodeissettolocal.See“mode”onpage 21‐18.
Syntax
lease-max <int>
Parameters
Examples
ThefollowingexamplesetsthemaximumtimetokeepaDHCP‐assignedIPaddressto2592000
seconds.
EWC.enterasys.com:topology:routed2:l3:dhcp# mode local
EWC.enterasys.com:topology:routed2:l3:dhcp# lease-max 2592000
EWC.enterasys.com:topology:routed2:l3:dhcp# apply
21.4.3.4.12 mode
UsethemodecommandtospecifythetypeofDHCPservertobeused.Themodecommandis
availablefromthetopology:<named‐topology>:l3:dhcpcontextoftheCLIforb@ac,physical,and
routedtopologies.
Syntax
•Forb@actopologies:mode local | relay | none
•Forphysicaltopologies:mode local | none
•Forroutedtopologies:mode local | relay
Parameters
Note: After you run the lease-default command, you must run the apply command to implement
the changes.
<int> Specifiesthetimelimitinseconds
Note: After you run the lease-max command, you must run the apply command to implement the
changes.
local IndicatesthatthecontrolleritselfactsastheDHCPserver