Specifications

Enterasys Wireless Controller Software CLI Reference Guide 21-15
21.4.3.4.4 dns
UsethednscommandtospecifytheIPaddressesforoneormoreDNSservers.Thednscommand
isavailablefromthetopology:<named‐topology>:l3:dhcpcontextoftheCLIforb@ac,physical,
androutedtopologies.Thiscommandisvisibleonlywhenmodeissettolocal.See“mode”on
page 21‐
18.
Syntax
dns (<DNS server> [,<DNS server> [...]]) | none
Parameters
Examples
Thefollowingexamplespecifies theIPaddressesoftwoDNSservers.
EWC.enterasys.com:topology:test:l3:dhcp# mode local
EWC.enterasys.com:topology:test:l3:dhcp# dns 192.168.1.2, 192.168.1.3
EWC.enterasys.com:topology:test:l3:dhcp# apply
21.4.3.4.5 domain
Usethedomaincommandtoconfigureadomainname.Thedomaincommandisavailablefrom
thetopology:<named‐topology>:l3:dhcpcontextoftheCLIforb@ac,physical,androuted
topologies.Thiscommandisvisibleonlywhenmodeissettolocal.See“mode”onpage 21‐18.
Syntax
domain <domain name> | none
Parameters
Examples
Thefollowingexamplesetsthedomainnameasmy‐domain.
EWC.enterasys.com:topology:test:l3:dhcp# mode local
EWC.enterasys.com:topology:test:l3:dhcp# domain my-domain
21.4.3.4.6 exclude
UsetheexcludecommandtoexcludeanIPaddressorarangeofIPaddressesfromtheDHCP
AddressRange.Theexcludecommandisavailablefromthetopology:<named‐topology>:l3:dhcp
<DNSserver> SpecifiestheIPaddressofaDNSserver
none ClearstheDNSserver
Note: After you run the dns command, you must run the apply command to implement the
changes.
<domainname> SpecifiesthedomainnameoranIPv4address.
none Clearsthedomainname.