Specifications

Enterasys Wireless Controller Software CLI Reference Guide 21-9
21.4.2.4 tagged
Usethetaggedcommandtoenableordisable802.1QVLANtagging.Thetaggedcommandis
availablefromthetopology:<named‐topology>:l2contextoftheCLIforb@apand physical
topologies.
Syntax
tagged enable | disable
Parameters
Examples
Thisfollowingexampleenables802.1QVLANtaggi ngonthephysicaltopologynamedesa1.
EWC.enterasys.com:topology:esa1:l2# tagged enable
21.4.2.5 vlanid
UsethevlanidcommandtoconfiguretheVLANIDofaphysicaltopologyorchangetheVLAN
IDofb@acorb@aptopologies. Thevlanidcommandisavailablefromthetopology:<named‐
topology>:l2contextoftheCLIforb@ac,b@ap,andphysicaltopologies.
Syntax
vlanid <1-4094>
Parameters
Examples
ThisfollowingexamplesetstheVLANIDofthetopologynamedtestto2.
EWC.enterasys.com:topology:test:l2# vlanid 2
21.4.3 l3
Usethel3commandtoenterthetopology:<named‐topology>:l3contextoftheCLIforadmin,
b@ac,physical,androutedtopologies.Thel3contextallowsyoutoconfiguretheLayer3
functionalityofthetopology.Thel3contextisavailableinb@acmodeonlyifl3presenceissetto
enable.For
moreinformation,see“l3presence”onpage 21‐30.
Thefollowingcommandsareavailableinthetopology:<named‐topology>:l3context.
• ap‐register
• cert
• copy‐csr
• dhcp—Seedhcpforcommandsinthetopology:<named‐topology>:l3:dhcpcontext.
enable Indicatesthat802.1QVLANtaggingwillbeenabled.
disable Indicatesthat 8 02.1QVLANtaggingwillbedisabled.
<1‐4094> TheVLANIDthatyouwanttoassigntothetopology.