Specifications

Enterasys Wireless Controller Software CLI Reference Guide 21-5
21.4.2 l2
Usethel2commandtoenterthetopology:<named‐topology>:l2contextoftheCLIforb@ac,
b@ap,physical,androutedtopologies.Thel2contextallowsyoutoconfiguretheLayer2
functionalityofthetopology.
Thefollowingcommandsareavailableinthetopology:<named‐topology>:l2context.
• multicast—Seemulticastforcommandsin
thetopology:<named‐topology>:l2:multicast 
context.
• port
• show
• tagged
• vlanid
21.4.2.1 multicast
Usethemulticastcommandtoenterthetopology:<named‐topology>:l2:multicastcontextofthe
CLIforb@acandroutedtopologies.
Thefollowingcommandsareavailableinthetopology:<named‐topology>:l2:multicastcontext.
• config
• create
• delete
• filter
• move
21.4.2.1.1 config
Usetheconfigcommandtoconfigureanexistingmulticastfilter.Theconfigcomm andis
availablefromthetopology:<named‐topology>:l2:multicastcontextoftheCLIfor b@acand
routedtopologies.
Syntax
config <pos>|default (A.B.C.D[/<0-32>] | vocera | svp) on|off
Parameters
Note: To create a multicast filter, use the create command. See “create” on page 21-6.
<pos>|default Specifiesthepriorityoffilterrule(0–255)ordefaultfilterrule.
A.B.C.D[/<0‐32>]|vocera|
svp
SpecifiestheIPaddressandmaskofamulticastgrouporthat
themulticastgroupispre‐defined.
• svp: Spectralink SVP (224.0.1.116)
• vocera: Vocera Mcst (230.230.0.0/20)
on|off Specifieswhetherwirelessreplicationisenabled.Thedefaultis
off.