Specifications

Enterasys Wireless Controller Software CLI Reference Guide 21-1
21
topology Commands
Thissectiondescribescommandsusedtodefineandconfiguretopologyobjectsusedbypolicy
andVNSobjects.ThesecommandsarelocatedinthetopologycontextoftheCLI.Executethe
topologycommandattherootleveltoentertoplogycontext.
Thefollowingcommandsareavailableinthetopologycontext:
• create
• delete
• <named‐topology>—See<named‐topology>forcommandsinthetopology:<named‐
topology>context.
• show
21.1 create
UsethecreatecommandtocreateaEnterasysWirelessControllertopologyobject.Thecreate
commandisaccessiblefromthetopologycontextoftheCLI.
Syntax
create <topology name> b@ac <vlanid> port <port name>} |
b@ap <-1 | vlanid> | routed <A.B.C.D/32>
Parameters
Note: All CLI commands cache changes. For this reason, sometimes when you make a change in a
particular context, the change may not be visible immediately. If this happens, you must exit and re-
enter the context in order to ensure that the database is synchronized with the latest change.
Note: The topology context was introduced with V7.11.
<topologyname> Specifiesthenameofthe topology.
b@ac<vlanid>port<port
name>
SpecifiestheVLANIDandtheporttowhichtheVLANis
attachedforatopol ogythatisbridgedlocallyatthecontroller.
b@ap<‐1|vlanid> SpecifiestheVLANIdforatopologythatisbridgedlocallyat
the
AP.
routed<A.B.C.D/32> SpecifiestheIPv4IPaddressandmaskforaroutedtopology.