Specifications

20-6 policy Commands
Ifthefilter‐statuscommandissettono‐change,anyfiltersthatexistinthepreviouspolicyare
appliedtothisuser.Forexample,ifthepreviouspolicyisthedefault‐policy,default‐policyfilters
areappliedtothisuser.
Theshow<named‐policy>command,withinthepolicycontext, and
theshowcommand,withina
policy:<named‐policy>context,specifythecurrentfilter‐statuscommandsettingwiththeline“Do
notchangefiltersettingswhenthisPolicyisapplied:”.
Examples
ThefollowingexampleenablesaccesstoACandAPfilterconfigurationwithinthep1<named‐
policy>context:
EWC.enterasys.com:policy:p1# filter-status enable
EWC.enterasys.com:policy:p1# apply
EWC.enterasys.com:policy:p1# show
Assigned topology: Seg1_Routed
Ingress rate profile: no change
Egress rate profile: no change
Do not change filter settings when this Policy is applied: enable
Name: Auth
Synchronize: disable
20.5.3 name
Usethenamecommandtochangethenameofapolicy.Thenamecommandisaccessiblefrom
withinthethepolicy:<named‐policy>context.
Syntax
name <new-name>
Parameters
Usage
Youmustentertheapplycommandbeforeexitingthepolicy:<named‐policy>contextforthe
policynamechangetotakeaffect.TheCLIpromptwillnotchangeuntilyouexitandre‐enterthe
policy:<named‐policy>context.
Examples
Thefollowingexample:
• Renamesthepolicyp1topolicy1
•Appliesthechange
•Displaysthepolicy1configuration
•Exitspolicy:<named‐policy>context
•Re‐entersthepolicy:<named‐policy>contextaspolicy1
EWC.enterasys.com:policy# p1
<new‐name> Specifiesthenewnameforthis<named‐policy>.