Specifications

19-58 wlans Commands
post-authentication timeout(minutes): 30
session timeout(minutes): 0
Block MU to MU traffic: disable
ThisexampledisplaysthesettingsforthedynamicmeshWLANservicenamedmesh1‐wlan.
EWC.enterasys.com:wlans:mesh1-wlan# show
Service type: mesh
Pre-shared Key:
SSID: mesh1
Backhaul Radio Band: a
Name: mesh1-wlan
Enable/disable WLAN Service: enable
aplist-wds 0500008043050236 portal wkgbridge on
Radio Mode: off
19.6.17 ssid
UsethessidcommandtospecifytheServiceSetIdentifier(SSID)fortheWLANservicebeing
configured.Thessidcommandisaccessiblefromthewlan:<WLAN‐service‐name>contextofthe
CLI.
Syntax
ssid <string>
Parameters
Examples
Thefollowingexamplespecifies theSSIDandthendisplaysit
EWC.enterasys.com:wlans:test# ssid testssid
EWC.enterasys.com:wlans:test# apply
EWC.enterasys.com:wlans:test# show ssid
SSID: testssid
19.6.18 status
UsethestatuscommandtoenableordisablethisWLANservice.Thestatuscommandis
accessiblefromthewlans:<WLAN‐service‐name>contextoftheCLI.
Syntax
status enable | disable
<string> SpecifiesastringfortheSSID.TheSSIDstringcanrangeinlength
from1to32characters.
Note: After you run the ssid command, you must run the apply command to implement the
changes.