Specifications

19-50 wlans Commands
Parameters
Usage
Thiscommandisonlyactiveifthepriority‐overridecommandhasbeenenabled.Formore
information,see“priority‐override”onpage 19‐48.
Examples
ThefollowingexampleoverridesallexistingServiceClasssettingsandconfiguresasingleService
Classof4fortheCNL‐7‐CPWLANS:
EWC.enterasys.com:wlans:CNL-7-CP:qos_policy# priority-override-up 4
EWC.enterasys.com:wlans:CNL-7-CP:qos_policy# apply
EWC.enterasys.com:wlans:CNL-7-CP:qos_policy# show priority-override-up
Service class: 4
19.6.13.9 turbo-voice
Usetheturbo‐voicecommandtoenableordisableTurboVoiceoptimization.Theturbo‐voice
commandisaccessiblefromthewlan:<WLAN‐service‐name>:qos‐policycontextoftheCLI.
Syntax
turbo-voice enable | disable
Parameters
Usage
Thiscommandisonlyactivewheneitherthewmm,802.11e,orlegacycommandshavebeen
enabled.
Examples
ThefollowingexampleenablesTurboVoiceontheCNL‐7‐CPWLANS:
EWC.enterasys.com:wlans:CNL-7-CP:qos-policy# turbo-voice enable
EWC.enterasys.com:wlans:CNL-7-CP:qos-policy# apply
EWC.enterasys.com:wlans:CNL-7-CP:qos-policy# show turbo-voice
Turbo voice: enable
<0‐7> SpecifiesaServiceClassvalue.Defaultvalue:1.
Note: After you run the priority-override-up command, you must run the apply command to
implement the changes.
enable|disable EnablesordisablesTurboVoiceoptimizationonthe
WLANS
Note: After you run the turbo-voice command, you must run the apply command to implement the
changes.