Specifications

19-42 wlans Commands
Input method: input string
WEP string: Sl==p
19.6.11.4 wpa-broadcast-rekey
Usethewpa‐broadcast‐rekeycommandtoconfigurethere‐keyintervalforgroupkeys.Thewpa‐
broadcast‐rekeycommandisaccessiblefromthewlan:<WLAN‐service‐name>:privcontextofthe
CLI.
Syntax
wpa-broadcast-rekey none | <30-86400>
Parameters
Usage
Thewpa‐broadcast‐rekeycommandisavailablewhentheprivacymodeissettowpaorwpa‐psk.
Formoreinformation,see“mode”onpage 19‐40.
Examples
ThefollowingexamplesetstheWPAre‐keyintervalto300seconds:
EWC.enterasys.com:wlans:test:priv# wpa-broadcast-rekey 300
EWC.enterasys.com:wlans:test:priv# apply
EWC.enterasys.com:wlans:test:priv# show wpa-broadcast-rekey
Broadcast re-key interval (seconds): 300
19.6.11.5 wpa-v1
Usethewpa‐v1commandtoconfiguretheWPAv1encryptionprotocol.Thewpa‐v1commandis
accessiblefromthewlan:<WLAN‐service‐name>:privcontextoftheCLI.
Syntax
wpa-v1 auto | tkip | none
Parameters
Note: After you have run the wep command, you must run the apply command to implement the
name change.
none Disablesthere‐keyintervalforgroupkeys
<30‐86400> Specifiesthere‐keyintervalforgroupkeysinseconds
Note: After you have run the wpa-broadcast-rekey command, you must run the apply command
to implement the name change.
auto|tkip|none SpecifiestheWPA v1 encryptionprotocol