Specifications

19-38 wlans Commands
Examples
Thisexampleselectsthe5GHzradiobandforthedynamicmeshWLANservicenamedmesh1‐
wlan.
EWC.enterasys.com:wlans:mesh1-wlan# backhaul-radio a
19.6.7 default-topology
Usethedefault‐topologycommandtoassignanexistingB@AC,B@AP,orroutedtopologyasthe
defaulttopologyforthespecifiedWLANservice.Youcanalsousethedefault‐topology
commandtounassignthedefaulttopology.Thedefault‐topologycommandisaccessiblefromthe
wlans:<WLAN‐service‐name>contextoftheCLI.
ForinformationaboutB@AC,B@AP,androutedtopologies,refertoChapter 21,topology
Commands.
Syntax
default-topology <Default topology name> | none
Parameters
Examples
ThefollowingexampleassignsthetopologyFS‐REMOTEtotheWLANservice.
EWC.enterasys.com:wlans:gp1# default-topology FS-REMOTE
19.6.8 direct-client-traffic
Usethedirect‐client‐trafficcommandtoenableordisabletheblockingofdirectclienttoclient
communication.Thedirect‐client‐trafficcommandisaccessiblefromthewlans:<WLAN‐service‐
name>contextoftheCLI.
Syntax
direct-client-traffic enable | disable
Parameters
Examples
Thefollowingexamplespecifies toblockdirectclienttoclientcommunication:
EWC.enterasys.com:wlans:test# direct-client-traffic enable
EWC.enterasys.com:wlans:test# apply
EWC.enterasys.com:wlans:test# show direct-client-traffic
Block MU to MU traffic: enable
Defaulttopol ogyname SpecifydefaulttopologytoassigntotheWLANservice
none Unassignthedefaulttopol ogyfromtheWLANservice
enable Specifytoblockdirectclienttoclientcommunication
disable Specifytoallowdirectclienttoclientcommunication