Specifications

19-36 wlans Commands
Parameters
Usage
YoumustbeinRADIUSserverconfigurationmodefortheprotocolcommand tobeavailable.Use
theconfigcommandtoenterRADIUSserverconfigurationmode.Formoreinformation,see
“config”onpage 19‐28.
Examples
ThefollowingexampleconfigurestheCHAPprotocolastheauthenticationprotocolforthis
RADIUSserver:
EWC.enterasys.com:wlans:cnl-AAA:auth# protocol CHAP
EWC.enterasys.com:wlans:cnl-AAA:auth# apply
19.6.5.24 remove
Theremovecommandwithincontextwlan:<WLAN‐service‐na me>:authremovesthespecified
RADIUSserverfromthelistofconfiguredRADIUSservers.
Syntax
remove <radius>
Parameters
Examples
ThefollowingexampleremovedtheRADIUSserver“radius1”fromthelistofRADIUSserversto
beusedwiththe“new‐wlans”WLAN:
EWC.enterasys.com:wlans:new-wlans:auth# remove radius1
CHAP ConfigurestheChallengeHandshakeAuthenticationProtocolasthe
authenticationprotocol
PAP ConfiguresthePasswordAuthenticationProtocolasthe
authenticationprotocol
MS‐CHAP Configures the Windows specific version of CHAP as
the authentication protocol
MS‐CHAP2 Configures the Windows specific version (Version 2)
of CHAP as the authentication protocol
Note: After you run the protocol command, you must run the apply command to implement the
changes.
<radius> SpecifiesthenameoftheRADIUSservertoremove