Specifications

Enterasys Wireless Controller Software CLI Reference Guide 19-35
Examples
ThefollowingexamplesetstheNASIPaddressforthisRADIUSserverconfigurationtotheVNS
IPaddressforthecnl‐AAAWLANSauthcontext:
EWC.enterasys.com:wlans:cnl-AAA:auth# nasip vnsip
EWC.enterasys.com:wlans:cnl-AAA:auth# apply
EWC.enterasys.com:wlans:cnl-AAA:auth# show nasip
NAS identifier: Use VNS IP address
19.6.5.22 password
UsethepasswordcommandtospecifytheMACauthentica tionpasswordtobeusedwiththe
RADIUSserverbeing configured.ThepasswordcommandisaccessiblefromwithintheRADIUS
serverconfigurationmodefromthewlans:<WLAN‐service‐name>:authcontextoftheCLI.
Syntax
password <password>
Parameters
Usage
YoumustbeinRADIUSserverconfigurat ionmodeforthepasswordcommandtobeavailable.
UsetheconfigcommandtoenterRADIUSserverconfigurationmode.Formoreinformation,see
“config”onpage 19‐28.
Examples
ThefollowingexamplesetstheMACauthenticationpasswordtotechdoc:
EWC.enterasys.com:wlans:cnl-AAA:auth# password techdoc
EWC.enterasys.com:wlans:cnl-AAA:auth# apply
19.6.5.23 protocol
UsetheprotocolcommandtoconfiguretheauthenticationprotocoltobeusedwiththeRADIUS
serverbeingconfigured.Theprotocolcommandisaccessiblefromthewlans:<WLAN‐service‐
name>:authcontextoftheCLI.
Syntax
protocol CHAP | PAP | MS-CHAP | MS-CHAP2
Note: After you run the nasip command, you must run the apply command to implement the
changes.
<password> SpecifytheMACauthenticationpassword
Note: After you run the password command, you must run the apply command to implement the
changes.