Specifications

19-34 wlans Commands
Parameters
Usage
TheNASIDdefaultstotheVNSnameifthiscommandisnotusedtospecifyaNASID.
YoumustbeinRADIUSserverconfigurat ionmodeforthenasidcommandtobeavailable.Use
theconfigcommandtoenterRADIUSserverconfigurationmode.Formoreinformation,see
“config”on
page 19‐28.
Examples
ThefollowingexamplesetstheNASIDforthisRADIUSserverconfigurationtotheVNSnamefor
thecnl‐AAAWLANSauthcontext:
EWC.enterasys.com:wlans:cnl-AAA:auth# nasid vnsname
EWC.enterasys.com:wlans:cnl-AAA:auth# apply
EWC.enterasys.com:wlans:cnl-AAA:auth# show nasid
NAS identifier: Use VNS name
19.6.5.21 nasip
UsethenasipcommandtoconfiguretheNASIPaddresstobeusedwiththeRADIUSserver
beingconfigured.Thenasipcommandisaccessiblefromthewlans:<WLAN‐service‐name>:auth
contextoftheCLI.
Syntax
nasip <A.B.C.D> | vnsip
Parameters
Usage
TheNASIPaddressdefaultstotheVNSIPaddressifthiscommandisnotusedtospecifyaNAS 
IPaddress.
YoumustbeinRADIUSserverconfigurat ionmodeforthenasipcommandtobeavailable.Use
theconfigcommandtoenterRADIUSserverconfigurationmode.Formoreinformation,see
“config”onpage 19‐28.
<string> SpecifytheIDfortheNAS
vnsname SpecifiesthattheVNSnameshouldbeusedfortheNASID
Note: After you run the nasid command, you must run the apply command to implement the
changes.
<A.B.C.D> SpecifytheNASIPaddress
vnsip SpecifiesthattheVNSIPaddressshouldbeusedfortheNASIP
address