Specifications

19-28 wlans Commands
Parameters
Usage
Thecdrcommandisavailableinallauthenticationmodes.Formoreinformation,see“mode”on
page 19‐32.
Examples
ThefollowingexampleenablesthecollectionofWirelessControlleraccountinginformation:
EWC.enterasys.com:wlans:test:auth# cdr enable
EWC.enterasys.com:wlans:test:auth# apply
EWC.enterasys.com:wlans:test:auth# show cdr
Collecting accounting information of Wireless Controller: enable
19.6.5.11 config
TheconfigcommanddefinesRADIUSserversettingsforthenamedWLANserviceinthecurrent
context,overridingdefaultRADIUSserverconfiguration.Theconfigcommandisaccessiblefrom
thewlan:<WLAN‐service ‐name>:authcontextoftheCLI.Usethi scommandtoconfigurethe
RADIUSserverasanaccounting,authenticationorMACauthenticationserver.
Syntax
config (<radius> (role acct|auth|mac) [prot CHAP | PAP | MS-CHAP | MS-CHAP2])
Parameters
Usage
Theconfigcommandisnotavailablewhentheau thenticationmodeisguestportal.Whenthe
authenticationmodeisdisabled,MACmustbeenabledforthiscommandtobeavailable.For
authenticationmodecommandinformation,see“mode”onpage 19‐32.Formaccommand
information,see“mac”onpage 19‐30.
Forthird
partyAPsSSIDs,thiscommandisonlyvisiblewhenmacissettoenableandonlymac
authenticationissupported.
AfterexecutingtheconfigcommandtoconfigureaRADIUSserver,youcanproceedtoconfigure
additionalserverattributessuchasNASIDandNASIPaddress.Whenyouarefinished
enable
|disable SpecifiestoenableordisablethecollectionofWireless
Controlleraccountinginformation
Note: After you run the cdr command, you must run the apply command to implement the
changes.
<radius> SpecifiesthenameoftheRADIUSservertoconfigure
roleacct|au th|mac SpecifiestheroleoftheRADIUSserverasaccounting,
authentication,orMACauthenticationserver,respectively.
protCHAP|PAP|
MS‐CHAP|MS‐CHAP2]
SpecifiestheAuthenticationtype