Specifications

Enterasys Wireless Controller Software CLI Reference Guide 19-21
ForaEnterasysWirelessControllerC20Nthesyntaxis:
extcpip (PC.<X>|eth0):<port>
ForaEnterasysWirelessControllerC4110thesyntaxis:
extcpip port<X>:<port>
Parameters
Usage
Eithertheexternalauthenticationmodeor802.1xwithaaa ‐redirmustbesetforthiscommandto
beavailable.Formoreinformation,see“mode”onpage 19‐32.
Examples
Thefollowingexamplespecifies theinterfaceand portofanexternalEnterasysWireless
Controller:
EWC.enterasys.com:wlans:CNL-7-CP:auth:captiveportal# extcpip esa0:32850
EWC.enterasys.com:wlans:CNL-7-CP:auth:captiveportal# apply
19.6.5.9.6 extredir
Usetheextredircommand,withincontextwlan:<WLAN‐service‐name>:auth:captiveportal,to
specifythe External RedirectionURL.
Syntax
extredir <value_string> | none
Parameters
Usage
Theexternalauthenticationmodemustbesetforthiscommandtobeavailable.Formore
information,see“mode”onpage 19‐32.
PC.<X> Indicatesthataphysicaldataportwillbeused,whereXisan
identificationnumberbetween0and3.
esa<X> Indicatesthataphysicaldataportwillbeused,whereX
isan
identificationnumberbetween0and3
port<X> Indicatesthataphysicaldataportwillbeused,whereXisan
identificationnumberbetween1and4
eth0 Indicatesthatthemanagementinterfacewillbeused
<port> S pecifiestheportnumberwithintherange:32768‐65535
Note: After you run the extcpip command, you must run the apply command to implement the
changes.
<value_string> SpecifiesaURLbeginningwithhttp://
none SpecifiesthatnoexternalredirectionURLisconfigured