Specifications

Enterasys Wireless Controller Software CLI Reference Guide 19-17
19.6.5.7 auth-topology
Usetheauth‐topologycommandtoincludetopologyinformationinthemessagetotheRADIUS
server.Theauth‐topologycommandisaccessiblefromthewlan:<WLAN‐service‐name>:auth
contextoftheCLI.
Syntax
auth-topology enable | disable
Parameters
Usage
Theauth‐topologycommandisnotavailablewhentheauthenticationmodeisguestportal.When
theauthenticationmodeisdisabled,MACmustbeenabledforthiscommandtobeavailable.For
moreinformation,see“mode”onpage 19‐32.
Examples
ThefollowingexampleenablestheinclusionofTopologyinformationinmessagestotheRADIUS
server:
EWC.enterasys.com:wlans:test:auth# auth-topology enable
EWC.enterasys.com:wlans:test:auth# apply
EWC.enterasys.com:wlans:test:auth# show auth-topology
Topology as VSA attribute: enable
19.6.5.8 auth-vns
Usetheauth‐vnscommandtoincludeVNSinformationinthemessagetotheRADIUSserver.The
auth‐vnscommandisaccessiblefromthewlan:<WLAN‐service‐name>:authcontextoftheCLI.
Syntax
auth-vns enable | disable
Parameters
Usage
Theauth‐vnscommandisnotavailablewhentheauthenticationmodeisguestportal.Whenthe
authenticationmodeisdisabled,MACmustbeenabledforthiscommandtobeavailable.For
moreinformation,see“mode”onpage 19‐32.
enable|disable SpecifiestoenableordisabletheinclusionofTopology
informationin
messagestotheRADIUSserver
Note: After you run this command, you must run the apply command to implement the changes.
enable|disable SpecifiestoenableordisabletheinclusionofVNS
informationinmessagestotheRADIUSserver